Health and safety in construction

Action will depend on the level of risk involved and what a business can control. This can be achieved through additional health and safety training for workers and improved working practices.

Have a written spill control plan. Train employees to clean up spills, protect themselves and properly dispose of used materials. The operator can determine the angle and length of the crane boom at all times.

Do not handle loads that are heavier than the capacity of the industrial truck. Overhead electrical power lines are located and identified. Material Safety Data Sheets are readily available at all times for each hazardous substance used.

All electrical tools and equipment are maintained in safe condition and checked regularly for defects and taken out of service if a defect is found. Elevated Surfaces Signs are posted, when appropriate, showing the elevated surface load capacity.

It has headquarters in Washington, DC and ten regional offices, further broken down into districts, each organized into three sections; compliance, training, and assistance. Head Protection Workers shall wear hard hats where there is a potential for objects falling from above, bumps to their heads from fixed objects, or of accidental head contact with electrical hazards.

Employees are not permitted to work on scaffolds when covered with snow, ice, or other slippery materials. Make this information accessible to employees at all times in a language or formats that are clearly understood by all affected personnel. Crane platforms and walkways have antiskid surfaces.

The Health and Safety Authority

All these facilities must be clean, safe, accessible and kept in good working order. Scaffolding Scaffolds should be set on sound footing. You can report an incident to WorkSafe by phoneor notifying WorkSafe online. In Norway, the main required tasks of an occupational health and safety practitioner include the following: All elevated surfaces beneath which people or machinery could be exposed to falling objects have standard 4-inch toeboards.

Load and forks are fully lowered, controls neutralized, power shut off and brakes set when a powered industrial truck is left unattended.

Material is piled, stacked or racked in a way that prevents it from tipping, falling, collapsing, rolling or spreading.

Health and Safety

Regulations to the OHS Act include:Advice, guidance, news, templates, tools, legislation, publications from Great Britain's independent regulator for work-related health, safety and illness; HSE. Construction is a high hazard industry that comprises a wide range of activities involving construction, alteration, and/or repair.

Examples include residential construction, bridge erection, roadway paving, excavations, demolitions, and large scale painting jobs. Occupational safety and health (OSH), also commonly referred to as occupational health and safety (OHS), occupational health, or workplace health and safety (WHS), is a multidisciplinary field concerned with the safety, health, and welfare of people at terms also refer to the goals of this field, so their use in the sense of this.

Providing affordable Health and Safety Training for the Construction Industry. Formed in we are a company limited by guarantee, with charitable status.

Health and safety in the construction industry

Resources. Learn everything you need about construction safety in our online resource centre. View Resources >. The Authority was established in under the Safety, Health and Welfare at Work Act, and reports to the Minister for Jobs, Enterprise and Innovation.

Health and safety in construction
Rated 4/5 based on 63 review